Features
- It has high radiopacity and mechanical strength
- Superior wear resistance
- High filler load
- Flowable consistency
- Low shrinkage
- Excellent colour stability
- Excellent flexural strength.
Description
Waldent Alchem Nanoflow Zirconium Flowable is an excellent flowable composite that delivers high strength & wears resistance. It is characterized by optimum surface affinity and penetrates easily into the most difficult areas. It combines esthetics as well as flow-on-demand handling for use.
Indications:
- Indicated for direct filling of class V (Cervical Caries)
- Root erosions
- Direct Veneers
- Wedge-shaped defects
- Fillings of anterior teeth (Class III & IV)
- Minimally invasive restorations
- Block out of undercuts
Specifications
- Diametric Tensile Strength 52,4 MPa
- Degree of conversion 83%
- Flexural modulus 12,6 GPa
- Shrinkage forces 0,91 MPa
- Diamond pyramid hardness 78 kg/mm²
- Thermal expansion coefficient 22 µm/m°C
- Flexural strength Nanoflow composite – 85 Mpa
- Compressive strength Nanoflow composite – 200 Mpa
Packaging
- 1 x A1 Shade (2gm)
- 1 x A2 Shade (2gm)
- 1 x A3 Shade (2gm)
- 1 x A3.5 Shade (2gm)
- 12 x Dispensing Tips
- 1 x Instruction Manual
Direct to Use
- Isolation: A rubber dam is the preferred method of isolation.
- Cavity preparation: Prepare cavity with minimal tooth reduction.
- Apply Etchant Gel to enamel and dentin surfaces for 15 seconds. Rinse thoroughly for 15 seconds with water.
- Dry with clean, oil-free, air without desiccating the dentin.
- Do not allow the etched surface to become contaminated with saliva or blood during the bonding procedure.
- Adhesive: Immediately after blotting, apply 2-3 consecutive coats of adhesive to etched enamel and dentin for 15 seconds with gentle agitation using a fully saturated applicator. Remove excess solvent by gently drying with dry air for at least 5 sec to ensure a uniform glossy surface. Light cure for 20-30 seconds.
- Apply the material with the applicator tip directly in the cavity and pre-contour with a suitable instrument.
- The layer should not be thicker than 2mm.
- Light cure for 40 sec using a standard curing light.
Reviews
There are no reviews yet.