Ivoclar Tetric N-Bond Universal viva-Pen

Tetric N-Bond Universal is the universal bonding agent available in VivaPen delivery for fast and convenient direct intra-oral application with minimal waste to optimize cost-effectiveness.

Tetric N-Bond Universal is a single-component, light-curing adhesive for direct and indirect bonding procedures that features compatibility with all etching techniques:  self-etch, selective-enamel-etch, and total-etch.

Indications

• Direct-placed light-curing composite and compomer restorations.
• Core build-ups with light-, self-, and dual-curing composites.
• Adhesive cementation of indirect restorations with light- and dual-curing luting composites with light-activation or in the self-curing mode.
• Intraoral repair of fractured composite and compomer restorations.
• Desensitization of hypersensitive cervical areas.
• Sealing of prepared tooth surfaces before temporary/permanent cementation of indirect restorations (e.g. Dual-Bonding Technique).

Packaging

  Ivoclar Tetric N-Bond Universal Pen only

• 1 x 2ml

  Ivoclar Tetric N-Bond Universal Tips Only

• 1 Box 100Pcs

  Ivoclar Tetric N-Bond Universal Pen With Tips

• 1 x 2ml (pen)
• 1 Box 100Pcs

Directions to Use

• Remove the VivaPen cap by turning it until noticeable resistance is felt and simultaneously pulling it off.
• Attach the VivaPen brush cannula. The cannula can be rotated up to approximately 270° to the desired position.

Attention: Rotating the cannula past the point of resistance will detach the cannula!

• For hygienic reasons, always use a VivaPen protective sleeve by sliding the Pen with the cannula into the protective sleeve until the cannula punctures through the sleeve.
• A new cannula and protective sleeve must be used for each patient.
• Activate the click mechanism 2-3 times until the cannula tip is sufficiently coated with Tetric N-Bond Universal. The wetting of the cannula tip is recognized by the yellow colour of Tetric N-Bond Universal.
• If used several times on the same patient, the moistened cannula must be protected from light.
• Remove the protective sleeve and cannula after using the VivaPen. Remove the cannula by turning it until noticeable resistance is felt and simultaneously pulling it off.
• Close the VivaPen with the original cap.