GC Tempsmart Cartridge Shade A2

TEMPSMART is an innovative, dual-cured, bis-acrylic composite temporary crown and bridge material using microfilled resin (MFR) and nano-filler technologies. TEMPSMART maintains a smooth surface after polishing because of this revolutionary combination. The high density polymer network for TEMPSMART makes it a strong material ideal for any sized provisional.

INDICATIONS

• Fabrication of temporary crowns, bridges, inlays, onlays and veneers
• Fabrication of long-term temporary restorations

Features

• Strong and durable
  TEMPSMART will virtually eliminate the risk of broken temporaries. Its significantly higher fracture toughness and flexural strength offer clinical longevity and make TEMPSMART the ideal material for any single or multi-unit temporary restoration.

• Fast
  TEMPSMART is dual-cured to allow adequate working time, yet rapid set, to give you the shortest overall chairside set time. A three-unit bridge can be completed in just 3 minutes.
• Smart
  Innovation in polymerization initiation and filler technology provides restorations that are non-sticky for ease of handling and require minimal polishing with high gloss retention. TEMPSMART maintains a smooth surface after polishing, reflecting natural tooth structure and fluorescence.
• First-in-class fracture toughness for clinical longevity
• Beautiful aesthetics as well as high gloss retention
• High flexural strength facilitates multi-unit temporization
• Quick working and setting times for the shortest chairside time
• A thin oxygen inhibition layer allows for better polymerization

Key Specifications

• Fracture toughness: 2.3Mpa√m
• Flexural strength: 101.4Mpa
• Gloss retention: 47.5 gloss unit
• Compressive strength: 446Mpa

Packaging

• 1 x 48ml Cartridge
• 16 x Mixing tips

Directions to Use

Step 1: Take a putty impression before preparation of the abutment teeth.
Step 2: Preparation of abutment teeth. Apply a separating medium.
Step 3: After bleeding the cartridge, inject TEMPSMART into the impression
Step 4: Seat the impression within 45 secs. of the start of the mix.
Step 5: Remove impression 2’00”-2’30” after the start of the mix. Remove any residual material at this time.
Step 6: Once removed from the mouth, complete polymerization by light-cure for 5 secs. per tooth.
Step 7: Trim excess material.
Step 8: Finish with silicon points and polish using a goat’s hair wheel. Alternatively, apply OPTIGLAZE color.
Step 9: Cement temporary using Fuji TEMP LT or FREEGENOL temporary cement.